As for not getting any in the tip, I’ve seen it done both ways. As for sanding the shaft, I don’t see a problem with that in the least, but please don’t go all crazy and sand into the shafts fibers. There is no reason to put the shaft into a vice for a reshaft. Get the 24 hour kind. Also put epoxy on the shaft to create a firmer bond, which is important for a driver. All times are GMT He works out of his home in Denver, Colo.
|Date Added:||7 August 2007|
|File Size:||29.36 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Once you have epoxy covering the tip, slide the head on and push until the shaft hits the bottom of the hosel. As for sanding the shaft, I don’t see a problem with that in the least, but please don’t go all crazy and sand into the shafts fibers.
Do not twist and pull the clubhead at any time, this could cause damage to the shaft. To do this, place a small amount of epoxy on the inside of the ferrule and slide the ferrule onto the shaft, narrow end first.
How to Reshaft a Golf Driver | Golfweek
Toulon Design Memphis H4 Ball: Still amazing me that he hits the graphite shaft on concrete to make sure the shaft is completed seated. Put it someplace where it wont be touched or disturbed and wait 24hrs. Edited by kcp04, 09 August – If the shaft is just barely too big, you can run some fine grit sandpaper over the area of resgaft shaft that will be inside the hosel until its the correct size.
Replace a Graphite Shaft on a Golf Club. If I need to shim it what should be used? Results 1 to 15 of Place your clubhead on top of the ferrule and place the grip end of the club on the floor.
How to Reshaft a Golf Driver
Roughed up the existing paint and sanded out bow couple large chips. And when I insert the shaft, I give it a slight twist Also put epoxy on the shaft to create a reshafr bond, which is important for a driver. One VERY important thing I forgot to mention, make sure the top of the hosel bore is “coned” to help prevent shaft breakage. The end result should be that if you run the tip of your finger around that edge it will not cut you and be very smooth.
How To Re-Shaft Your Graphite Golf Clubs
Make sure you don’t cut in to the shaft or create a flat spot by scraping too much. He works out of his home in Denver, Colo. M3 with Recoil Prototype shafts check out the M3 iron review thread Wedges: TP Ardmore 3 Ball: Then, put it somewhere it will not move and in a position that it is not leaning on the shaft, to ensure that the shaft stays straight in the hosel.
Will an epoxy mix from a hardware store work as well? Yours may ot well be done already, or even hoow for a collared ferrule.
Come back the next day and you have a new club. You will find a link to each tool used. With a popsickle stick or tee, apply reshaff epoxy onto the tip of the shaft, making sure not to get any on the very bottom of the tip it messes with the seal.
Do a little research and make sure you get this step right. Found it on Taylor Made Pre-Owned. Warm the ferrule using a Heat Gun. How To Reshaft Golf Clubs. Optional, but I do it this way.
I understand what you guys were getting at now and hopefully this will all work out. You either need a coned hosel and a coned ferrule to provide an epoxy “cushion” for the shaft, or a collared ferrule that matches up with the head you are working with.
Elevate Shafts in X Forged ’18 Irons. It just adds an unnecessary step to the process.